iSync Plugin Support

If you have any problems with our iSync Plugins there's a few things you can try which will help. The tips listed below have solved 100% of all issues reported.

Installation & Setup

• Confirming System Requirements
• Bluetooth Hardware
• Correct Plugin installation
• Error: "iSync 2.4 or later is required"
• Error: "iSync not found"
• Error: "iSync can't open because of a problem with a plug-in"
• iSync does not open automatically during the Phone Setup (Step 9)
• "This device is not supported by iSync" message
• Tips for setting up a successful first sync
• Sending SMS, making and receiving calls with Apple Address Book
• Removing/uninstalling the Phone Plugins

Syncing issues after Setup

• Please see our iSync Tips page

Confirming System Requirements

You must be running Mac OS X 10.4.9 or later with iSync 2.4 or later. These plugins will not run with any earlier versions of iSync.

The iSync application must be located in the main Applications folder of your boot-up hard disk.

You also need Apple supported Bluetooth hardware (see below) or a DCU-60 or DCU-65 USB cable for phones that support USB syncing.

Bluetooth Hardware

If your Mac doesn't have built-in Bluetooth hardware, please use a D-Link DBT-120 USB dongle, as this is the only one supported by Apple. Syncing via the DCU-60 or DCU-65 USB cable is only supported for some models.

Non-Apple supported Bluetooth hardware may not be compatible. Apple only supports the internal Bluetooth modules supplied as standard with their Macs, or the D-Link DBT-120 USB Bluetooth Adapter.

Some third-party USB Adapters are not fully compatible with the Mac (despite what they claim on the box). Pairing and File Transfers usually work ok, but syncing does not.

Other USB Adapters from other manufacturers may or may not work. If you have any definitive information on any not listed above, please let us know.

Correct Plugin installation

The Phone Plugin installer will automatically install the plugin to the correct place on your hard disk. Please check in [Your Hard Disk]/Library/PhonePlugins for a folder called Feisar-XXXX.phoneplugin (where XXXX is the model of your phone, for instance Feisar-K510.phoneplugin)

Error: "iSync 2.4 or later is required"

This message means that the version of iSync you have installed is not new enough. You need to be running iSync 2.4 or later which was released as part of the Mac OS X 10.4.9 Update.

If you are certain you have iSync 2.4 or later installed please read the next "iSync not found" section.

Error: "iSync not found"

The iSync application must be named "iSync" and should not be moved from its default location in the main Applications folder of your boot-up hard-disk. If you have moved or renamed the iSync application, please revert it back to its default name and location.

Error: "iSync can't open because of a problem with a plug-in"

This message appears if iSync support for the phone you are installing already exists. You can only have one plugin for each phone installed at any one time. This can occur in the following situations:

1) You have previously installed another iSync Plugin for the same phone from another source which is causing a conflict with ours. To resolve this:

• Navigate to [Your Mac HD]/Library/PhonePlugins/ and remove any other iSync Phone Plugins.

2) You have made modifications to iSync in an attempt to add support for your phone. To resolve this you can do one of the following:

• Un-do those changes, reverting iSync back to its unmodified state.
• Re-install a fresh unmodified copy of iSync by following the instructions here.

3) Apple has since added native support for your phone. To resolve this:

• If you are running iSync 2.4 under Mac OS X 10.4.x Tiger please click here.
• If you are running iSync 3.0 under Mac OS X 10.5.x Leopard please click here.

iSync does not open automatically during the Phone Setup

There are two possible causes for this:

• You are using incompatible Bluetooth hardware. Please see above for supported Bluetooth hardware.
• You have purchased and installed the wrong plugin for your phone. To check the model of phone you have, look at the label underneath the battery, or choose Settings > General > Phone Status then compare it with the filename of the Plugin you purchased. You can ignore the i, a or c at the end of the model number.

"This device is not supported by iSync" message

Please check the following:

• Look in [Your Hard Disk]/Library/PhonePlugins for a folder called Feisar-XXXX.phoneplugin (where XXXX is the model of your phone, for instance Feisar-K510.phoneplugin)
• If there is no PhonePlugins folder or it is empty, then you have not yet installed the Plugin.
• Please check that the installed plugin matches the model of the phone you have. To check the model of phone you have, look at the label underneath the battery, or choose Settings > General > Phone Status

Tips for setting up a successful first sync

From experience, we have found it is best to start with a completely empty phone. Attempting to merge existing data on the phone and the Mac isn't always successful.

If you have existing contacts on the phone, transfer them to the Mac and import them into Address Book.

Before your first sync, ensure your Address Book and iCal data is completely up-to-date, make a backup, then choose the Erase data on device then sync option from the For first sync: pop-up menu.

For best results, don't try to sync the whole of your Address Book contacts to the phone. Create a group in Address Book with only the contacts you need on the phone in it. Then, in iSync, click the icon for your phone, and choose the group you made from the Contacts - Synchronize: pop-up menu.

Syncing issues after setup

Please see our general iSync Tips page.

Sending SMS, making and receiving calls with Apple Address Book

The iSync Phone Plugins are not intended to enable Address Book support for your phone. iSync and Address Book are two independent applications. If you are using Mac OS X 10.4.x you can enable Call and SMS functions in Address Book for your phone, by clicking here.

Removing/uninstalling the Phone Plugins

• Quit iSync
• In the Finder, navigate to [Your Hard Disk]/Library/PhonePlugins
• Drag the relevant Feisar-XXXX.phoneplugin to the Trash (where XXXX is your phone model)